[Apr 20, 2024] Download Free Network Appliance NS0-194 Real Exam Questions
Pass Your Exam With 100% Verified NS0-194 Exam Questions
To take the NS0-194 exam, candidates need to have a strong understanding of NetApp storage systems, including hardware and software components. Candidates must also have experience in troubleshooting, installation, and configuration of NetApp storage systems. The NS0-194 exam is a challenging test, and candidates need to prepare thoroughly to pass the exam.
NEW QUESTION # 49
You received the "CLUSTER ERROR: DISK/SHELF COUNT MISMATCH" AutoSupport message from an ONTAP cluster.
When analyzing this message, which two should be inspected? (Choose two.)
- A. drive firmware
- B. drive paths
- C. SAS cabling
- D. IOM firmware
Answer: A,B
NEW QUESTION # 50
Referring to the exhibit.
A customer receives "CLUSTER NETWORK DEGRADED" AutoSupport messages from this clustered Data ONTAP system. The customer suspects that something occurred physically to the nodes after they had a data center maintenance move.
The customer proceeds to follow the instructions in the Knowledge Base article regarding the "Error: CLUSTER NETWORK DEGRADED" message that results in the output shown In the exhibit.
After analysis, the customer decides to replace the small form-factor pluggable (SFP) transceivers and the cables on the system.
Which statistic supports the customer's analysis?
- A. Multi/broadcast
- B. BCast pkts
- C. CRC errors
- D. Jumbo frames
Answer: C
NEW QUESTION # 51
Which two transport protocols would be used for SnapDrive for Windows in both 7-Mode and clustered Data ONTAP environments? (Choose two.)
- A. HTTP
- B. HTTPS
- C. RPC
- D. iSCSI
Answer: B,D
NEW QUESTION # 52
You have a 4-node MetroCluster configuration. The systems are operating normally with no faults.
In this scenario, which statement describes the usage of NVRAM when a host sends a write to a node?
- A. Incoming writes are written to the receiving node's NVRAM, its HA partner's NVRAM, and its DR partner's NVRAMonly.
- B. Incoming writes are written to the receiving node's NVRAM and its DR partner's NVRAM only.
- C. Incoming writes are written to the receiving node's NVRAM and its HA partner's NVRAM only.
- D. Incoming writes are written to the all four nodes' NVRAM.
Answer: B
NEW QUESTION # 53
Your customer calls to report that he is seeing many cyclic redundancy check (CRC) errors on the FC-AL loop.
Which three commands would you use to determine the cause? (Choose three.)
- A. fcstat link_stats <adapter name>
- B. fcp status
- C. fcadmin fcal_stats <adapter name>
- D. fcp stats <adapter name>
- E. fcadmin link_stats
Answer: A,C,D
NEW QUESTION # 54
Which two SVMs would benefit from a load-sharing mirror? (Choose two.)
- A. An SVM that is configured for NFS.
- B. An SVM that is configured for iSCSI.
- C. An SVM that is configured for FCP.
- D. An SVM that is configured for CIFS.
Answer: A,D
NEW QUESTION # 55
Referring to the exhibit.
A customer receives "CLUSTER NETWORK DEGRADED" AutoSupport messages from this clustered Data ONTAP system. The customer suspects that something occurred physically to the nodes after they had a data center maintenance move.
The customer proceeds to follow the instructions in the Knowledge Base article regarding the "Error: CLUSTER NETWORK DEGRADED" message that results in the output shown In the exhibit.
After analysis, the customer decides to replace the small form-factor pluggable (SFP) transceivers and the cables on the system.
Which statistic supports the customer's analysis?
- A. Multi/broadcast
- B. BCast pkts
- C. CRC errors
- D. Jumbo frames
Answer: C
NEW QUESTION # 56
You want to map an iSCSI LUN from a NetApp controller.
Which two components are required to accomplish this task? (Choose two.)
- A. igroup
- B. iSCSI initiator
- C. FCP zoning
- D. initiator WWPN
Answer: C,D
NEW QUESTION # 57
A customer is showing disk utilization is at 100% in Active IQ even though there are low protocol operations on the controller. You review the data shown in the exhibit.
In this situation, what should you do?
- A. Replace disks 6b.34 and 6a.19.
- B. Replace disk 6b.39.
- C. Add disks to the aggregate to bring down the average utilization.
- D. Reseat shelf module B.
Answer: B
NEW QUESTION # 58
A user complains that they cannot access a new NFS mount while logged into their Linux client. They are unable to mount the file system and are receiving an access denied error. The NFS server is a clustered Data ONTAP 8.3.1 storage virtual machine (SVM).
Which two steps should be taken to troubleshoot the problem? (Choose two.)
- A. Execute the vserver nfs show command on the clustered Data ONTAP cluster shell.
- B. Confirm that the NFS mount's underlying volume is set to the NTFS security style.
- C. Execute the mount command on the client to determine how NFS mounts are mounted.
- D. Verify that the access settings of the export policy's rule are applicable to the export.
Answer: C,D
NEW QUESTION # 59
You receive an AutoSupport notification because of the error shown below. "HA GROUP ERROR: DISK/SHELF COUNT MISMATCH ERROR."
In this scenario, which two steps would you take to solve the problem? (Choose two.)
- A. You should perform a failover and a giveback to clear the error.
- B. You should power cycle all the disk shelves to clear the error.
- C. You should examine the IOM modules for error lights and reseat.
- D. You should review the /etc/messages log.
Answer: B,D
NEW QUESTION # 60
You are creating a disk-partitioned root aggregate.
Which two rules are enforced automatically when accomplishing this task? (Choose two.)
- A. A RAID group can have more than one partition from the same disk.
- B. A RAID group cannot have more than one partition from the same disk.
- C. The only supported RAID type for aggregates containing root-data partitioned disks is RAID-DP.
- D. The only supported RAID type for aggregates containing root-data partitioned disks is RAID 4.
Answer: B,C
NEW QUESTION # 61
Referring to the exhibit, which two components should be examined? (Choose two.)
- A. network interface card
- B. disk
- C. cluster switches
- D. SAS adapter
Answer: B,D
NEW QUESTION # 62
You want to use the supported method to upgrade the ONTAP version of a Cloud Volumes ONTAP instance from ONTAP 9.5 to ONTAP 9.6.
In this scenario, which NetApp tool accomplishes this task?
- A. ONTAP System Manager
- B. Cloud Insights
- C. Active IQ Unified Manager
- D. Cloud Manager
Answer: A
NEW QUESTION # 63
You are using AFF storage with the NVMe storage protocol on your Linux clients.
In this scenario, which NVMe feature must be present and enabled for the client to see storage failover happen?
- A. Asymmetric Namespace Access (ANA)
- B. NVMe Qualified Name (NQN)
- C. Multi-Path I/O (MPIO)
- D. Asymmetric Logical Unit Access (ALUA)
Answer: C
NEW QUESTION # 64
A customer explains that their V3170 NetApp controller has failed over and they do not know what to do next.
In this scenario, what information should the customer collect from the Remote LAN Module (RLM) and send to you? (Choose two.)
- A. output from the sp status command
- B. output from the system log command
- C. output from the events info command
- D. output from the events all command
Answer: B,D
NEW QUESTION # 65
A large amount of data was deleted from a volume. After a few hours, the space was still not available to NFS clients accessing the volume.
What are two reasons that would account for this problem? (Choose two.)
- A. The deleted data was all deduplicated data.
- B. There is a thick-provisioned LUN in the volume.
- C. The client needs to re-scan the volume to detect the changes.
- D. The volume contains Snapshot copies that were taken before the data was deleted.
Answer: C,D
NEW QUESTION # 66
Which two statements are true about epsilon in a 4-node cluster? (Choose two.)
- A. Epsilon is automatically assigned to the last node added to a cluster.
- B. Epsilon is used as a tie-breaker for determining a quorum.
- C. Epsilon is used for determining the up node in failover.
- D. Epsilon is authentically assigned to the first node when a cluster is created.
Answer: B,D
NEW QUESTION # 67
......
Passing the NS0-194 certification exam is a significant achievement for IT professionals. It demonstrates their expertise in NetApp storage systems and validates their skills in supporting these systems. It also opens up new career opportunities and increases their earning potential. NetApp Certified Support Engineers are in high demand, and this certification can help IT professionals stand out in a competitive job market.
The NS0-194 exam is a comprehensive and challenging test that requires candidates to have a deep understanding of NetApp storage systems. To pass the exam, candidates must demonstrate their ability to install, configure and troubleshoot various NetApp storage hardware and software components. They must also be knowledgeable about NetApp's data management technologies, including data backup, data recovery, and data migration.
NS0-194 Dumps 100 Pass Guarantee With Latest Demo: https://topexamcollection.pdfvce.com/NetworkAppliance/NS0-194-exam-pdf-dumps.html